Alpine CDE-9845 Mode D'emploi page 24

1 Antenna Receptacle
2 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
3 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4 Illumination Lead (Orange) (CDE-9845/CDE-9843
only)
This lead may be connected to the vehicle's instrument
cluster illumination lead. This will allow the backlighting of
the unit to dim whenever the vehicle's lights are turned on.
5 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)12V
only when the ignition is turned on or in the accessory
position.
6 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
7 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
8 Power Supply Connector
9 Right Front (+) Speaker Output Lead (Gray)
! Right Front (–) Speaker Output Lead (Gray/Black)
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
" Right Rear (–) Speaker Output Lead (Violet/Black)
# Right Rear (+) Speaker Output Lead (Violet)
$ Left Rear (+) Speaker Output Lead (Green)
% Left Rear (–) Speaker Output Lead (Green/Black)
& Left Front (–) Speaker Output Lead (White/Black)
( Left Front (+) Speaker Output Lead (White)
) Front Output RCA Connectors (CDE-9845 only)
RED is right and WHITE is left.
~ Rear/Subwoofer Output RCA Connectors (CDE-9845
only)
~ Front/Subwoofer Output RCA Connectors (CDE-9843/
CDE-9841 only)
RED is right and WHITE is left.
+ Fuse Holder (10A)
, RCA Extension Cable (Sold Separately)
- AUX Input Terminal (CDE-9845 only)
This terminal allows for input of audio from an external
device, (such as a portable player), using a commercially-
available converter cable.
23
-EN