Setup Menu - Altec Lansing PT8051 Mode D'emploi

NTSC: Select this if the connected TV has the NTSC color system. It
will change the video signal of a PAL disc and output it to NTSC format.
PAL: Select this setting if the connected TV has the PAL color system. It
will change the video signal of an NTSC disc and output it to PAL format.
SETUP
OSD LANG
TV TYPE
CENTER DELAY
REAR DELAY
TEST TONE
SCREEN SAVER
EQ
DEFAULTS
EXIT SETUP
Center Delay Setting
Used to set the delay time that is used for the CENTER channel. This
setting is adjustable from 0 to 5 mS (milliseconds) in one millisecond
increments. This setting is useful if your PT8051 main unit cannot be
positioned near the TV. As a general rule one foot (30cm) is equal to a
delay of approximately 1mS. Therefore if your PT8051 main unit was
one foot from the screen you would set the CENTER delay for 1mS. It
can also be adjusted so that the sound coming from the PT8051 is
synchronized with the video image. The default setting is CENTER
DELAY TURNED OFF.
CENTER DELAY
REAR DELAY
TEST TONE
SCREEN SAVER
EQ
DEFAULTS
EXIT SETUP
SET CENTER DELAY
Rear Delay Setting
Used to set the delay time that is used for the REAR (surround)
channel. This setting is adjustable from 0 to 15mS (milliseconds) in
three millisecond increments. This setting is used to accurately
reproduce the surround information that is encoded on certain DVDs
as the producer intended by allowing you to tailor the sound to your
listening room size. In this case you would set the delay as follows;
The delay in milliseconds for the rear (surround) speaker setting is
equal to the number of feet closer that speaker is to your listening
position than the main unit.
For an example, let's assume the main unit is 15 ft away from the main
listening position and the rear (surround) unit is 5 feet away.
Surround's Delay = 15ft – 5ft = 10ft = 10mS of delay
In this case you would select 9 mS from the menu as it is closest to
10 mS.
The idea is to have the sound from the main and rear units reach your
ears at the same time, in relation to the signal being sent to those
speakers. For the speakers that are close to you, a delay has to be added
so that their sound reaches your ears at the same time as the speakers
MENU
AUTO
NTSC
PAL
CENTER DELAY SET TO 5MS
CENTER DELAY SET TO 4MS
CENTER DELAY SET TO 3MS
CENTER DELAY SET TO 2MS
CENTER DELAY SET TO 1MS
CENTER DELAY OFF
that are farther away from you, with respect to the music signal that is
sent to all the speakers at the same instant. The default setting is REAR
DELAY TURNED OFF.
CENTER DELAY
REAR DELAY
TEST TONE
SCREEN SAVER
EQ
DEFAULTS
EXIT SETUP
SET SURROUND DELAY
Test Tone Setting
When set to the ON position, the system will test the speaker output
by using an internally generated test tone. The test signal is output
sequentially through various channels. The default setting is OFF.
OSD LANG
CENTER DELAY
REAR DELAY
SCREEN SAVER
EQ
DEFAULTS
EXIT SETUP
Screen Saver Setting
When set to ON the PT8051 will automatically enter the screen saver
mode when no changes have been made after five minutes. This is
useful for preventing image burn from occurring that can damage
certain plasma TVs. The default setting is ON.
OSD LANG
CENTER DELAY
REAR DELAY
TEST TONE
EQ
DEFAULTS
EXIT SETUP
9
SURROUND DELAY SET TO 15MS
SURROUND DELAY SET TO 12MS
SURROUND DELAY SET TO 9MS
SURROUND DELAY SET TO 6MS
SURROUND DELAY SET TO 3MS
SURROUND DELAY TURNED OFF