Altec Lansing PT8051 Mode D'emploi page 11

Default Preprogrammed Remote Control Codes
Your PT8051 remote control is preset to the default codes listed in the
table below. If your component is not listed please consult the list in
the Preprogrammed Remote Control Codes section. You can also use the
search procedure in the Searching for Remote Control Codes section of
this manual.
Remote Button Initial code
TV
SAT/CAB
AUDIO
AUX
DVD
Programming Device Remote Control Codes
Find the brand, model and code number of your components in the
Preprogrammed Remote Control Codes section of this manual, then
follow these steps:
• While holding down the PROGRAM button, press the button for the
device to be programmed, i.e., TV or DVD or CAB/SAT or AUX.
• The Status LED illuminates.
• Release both buttons.
• Enter the CODE NUMBER using the numeric buttons on the remote.
If the CODE NUMBER is valid the LED will flash twice and then turn
off, indicating the code has been programmed. If the code number is
not valid the LED flashes twice and turns on;
• Check to see that the remote can control the device that was
programmed by using the CH+/– or similar button to control the
device that was programmed. If it does not control the device, repeat
this procedure.
Note: If you want to leave the setup mode, press the device button
(TV, SAT/CAB, DVD, etc.). If you do not press any buttons after 10
seconds, SETUP MODE exits automatically.
Searching for Remote Control Codes
If you cannot find a code number from the Preprogrammed Remote
Control Codes section of this manual that matches your equipment, the
PT8051 remote can search its database for a suitable control code from
the codes programmed into the remote. The PT8051 remote control
will find the best possible component code for any audio source.
To search for codes follow these steps:
• Turn the device (TV, SAT/CAB, DVD, AUX, etc) that you wish to locate
the remote control code for to the on position.
• On the PT8051 remote press and hold the PROGRAM button while
pressing the device button you wish to search for (TV, SAT/CAB, DVD,
AUX, etc).
• The STATUS LED on the PT8051 will illuminate and remain on.
• Press and release the PROGRAM button again. The LED will flash to
indicate that the remote has entered the search mode.
• Aiming the PT8051 remote at the device you want to control
repeatedly and slowly press and release the POWER button. The
PT8051 will send a different POWER code to the device each time
the POWER button is pressed.
Equipment
082 Philips TV
039 Philips Cable Box
900 Altec Lansing PT8051
144 Panasonic VCR
124 Sony DVD
• Once the device you wish to control powers off, immediately stop
pressing the POWER button and press the device (TV, SAT/CAB, DVD,
AUX, etc) button again.
• The PT8051 should now be programmed to control your device.
• You can verify this by turning the device on, and entering other
applicable commands such as PLAY or STOP for a DVD player or
CHANNEL +/– for a SATELLITE TV box.
Note: While the POWER button was used for searching here, you can
use other commands such as the PLAY button for devices that do not
have a POWER button. In this case the PT8051 uses the PLAY button to
search. Simply use the PLAY button instead of the POWER button as
described below ensuring that the device you wish to control is ready
to enter the play mode and has a DVD or tape loaded, is on, etc.
11