Special Safety Regulations - Hendi 273906 Mode D'emploi

ance pull the power plug out of the electrical outlet.
• Always turn the appliance off before disconnecting the plug.
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced phys-
ical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.

Special safety regulations

• Do not place the appliance near combustible objects.
• ATTENTION! This appliance is only suitable for use with R40 or BR40 types of incan-
descent light bulbs (2 light bulbs included, to be ordered as spare part: article number
919200).
• Do not install light bulbs with a power level greater than 250 Watts.
Danger of burns: Do not touch the appliance while in use. The appliance becomes
•
hot during use.
• Always allow the appliance to completely cool down before cleaning. The bulb shell is still
EN
very hot even switch off for some time.
• Warning! Make sure the appliance is placed firmly on a stable, level & horizontal surface.
• Caution! Make sure the screw for height adjustment is tightened firmly.
Grounding Installation
This appliance is classified as the protection class I
and must be connected to a protective ground.
Grounding reduces the risk of electric shock by pro-
viding an escape wire for the electric current. This
Preparation for first use
• Check to make sure the appliance is undamaged.
In case of any damage, immediately contact your
supplier and do NOT use the appliance.
• Remove all packaging material and protection film
(if applicable).
• Clean the appliance as explained below at the
cleaning and maintenance topic.
• Position the appliance in such a way that the plug
is accessible at all times.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
4
appliance is equipped with a cord having a groun-
ding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and
grounded.
• Place the support arm into the stand.
• Set the height of the support arm and insert the
screw to lock the arm in place.
• Tighten the mounted light bulbs well.
• The new light bulbs will process fumes for about 3
till 4 hours (smoke & odor).
Note: GN container not included! Suitable for GN 1/1
container.