Hendi 273906 Mode D'emploi page 5

Usage
• Insert the 2 light bulbs (included).
• Insert the plug into a grounded socket. ATTEN-
TION! There is a chance for electrical shocks when
not using a grounded socket.
• Turn on the appliance using the switch.
• Place the food in a pan or equivalent directly under
the light bulbs for the best results.
• If you don't use the appliance anymore the appli-
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
Faults
Storing Possible cause
The appliance does The plug is not plugged (correctly) into
not work the electrical outlet.
Switch is off
Light bulbs are loose or are defective
In case of any doubt, always contact your supplier!
Technical data
Supply voltage 230-240 V/50 Hz
Technical data is subjected to change without prior notice.
Warranty
Any defect affecting the functionality of the appli-
ance which becomes apparent within one year after
purchase will be repaired by free repair or replace-
ment provided the appliance has been used and
maintained in accordance with the instructions and
has not been abused or misused in any way. Your
statutory rights are not affected. If the appliance is
claimed under warranty, state where and when it
Discarding & Environment
At the end of the life of the appliance, please dispo-
se of the appliance according to the regulations and
guidelines applicable at the time.
ance can be turned off using the switch.
• If the appliance is not being used for a longer peri-
od of time, remove the plug from the socket.
• ATTENTION! The light bulbs and other parts of the
appliance can get hot while operating the appli-
ance.
• ATTENTION! Allow the appliance to cool down
completely before touching it.
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects. Do
not use petrol or solvents! Clean with a damp cloth
and detergent if necessary. Do not use abrasive
materials.
• Turn off the appliance before replacing any light
bulbs.
Possible solution
Check the plug
Turn the switch on
Tighten or replace the light bulb
Power 500 W
was purchased and include proof of purchase (e.g.
receipt).
In line with our policy of continuous product deve-
lopment we reserve the right to change the pro-
duct, packaging and documentation specifications
without notice.
Throw packing materials like plastic and boxes in
the appropriate containers.
EN
5