Emc−Compliant Wiring - Lenze 2102-V Série Instructions De Montage

6 Electrical installation
EMC−compliant wiring
EMC−compliant wiring
For wiring according to EMC requirements observe the following points:
)
Note!
Separate control/data cables from motor cables.
ƒ
In case of digital signals, connect the shields of control/data cables on both
ƒ
sides.
Use an equalizing conductor with a cross−section of at least 16 mm
ƒ
avoid potential differences between the bus nodes (reference: PE).
Observe the other notes concerning EMC−compliant wiring given in the
ƒ
documentation for the standard device.
62
l
2
to
EDKMF2102 DE/EN/FR 8.0