Kicker QS Série Manuel D'utilisation page 8

CROSSOVER MOUNTING
Mount the crossover in a location that is easy to access for wiring. Make sure that the crossover will not
be exposed to water. The bottom of the car door is not a good location. If you must mount the crossover
in the car door, exercise caution as water can accumulate in the bottom of the door. Keep the crossover
high in the door and shielded from water.
The speaker wire should be kept away from sharp edges and avoid the possibility of getting pinched by
the door. An existing grommet in the door jamb is the ideal place to run the speaker wire. If the factory
hole and grommet do not exist or are inaccessible, you must drill a hole to run the speaker wire through
the door jamb. Be careful not to drill into other wiring or existing door mechanisms. Any time a wire is run
through a hole, it is necessary to insert a rubber or plastic grommet to protect the wire from damage.
8
woofer mounting hole
QS crossover.
(mounted inside
door panel)
to woofer
terminals
rubber
grommets
door jamb
from amplifier or
source unit