English
IMPORTANT SAFETY INSTRUCTIONS FOR
USE OF THE CORDLESS IMPACT DRIVER
WARNING:
Death or serious bodily injury could result from
improper or unsafe use of the cordless impact
driver. To avoid these risks, follow these basic
safety instructions:
1.
Never use this driver handle for any application
other than those in this manual.
2.
Never place hands or other body parts near the
drill bit or chuck during operation.
Hold the impact driver by its handle only.
3.
When working in high places, always make sure
that ther is no one below before starting to work.
4.
Always wear eye and ear protection when you
work.
5.
Always install the driver bit securely. A loose bit is
dangerous because it can come loose while you
are working.
6.
Always use the driver bit that matches the screw
size.
7.
Always have the screw you are screwing in and
this impact driver in a straight line. Working with
this impact driver at an angle to the screw can
damage the screw head and will not give the
prescribed tightening torque.
IMPORTANT SAFETY INSTRUCTIONS FOR
BATTERY CHARGER
WARNING:
Death or serious bodily injury could result from
improper or unsafe use of battery chargers. To
avoid these risks, follow these basic safety
instructions:
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
*
If the input rating of a battery charger is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating–for example:
1,250 watts
125 volts
6
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
= 10 amperes
READ ALL INSTRUCTIONS
1. This manual contains important safety and
operating instructions for battery charger Model
UC18YGL.
2. Before using battery charger, read all instructions
and cautionary markings on (1) battery charger,
(2) battery, and (3) product using battery.
3. To reduce risk of injury, charge HITACHI
rechargeable battery type BCL1415, BCL1430,
BCL1815 and EBM1830. Other type of batteries
may burst causing personal injury and damage.
4.
Do not expose battery charger to rain or snow.
5.
Use of an attachment not recommended or sold
by the battery charger manufacturer may result in
a risk of fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord,
pull by plug when disconnecting battery charger.
7. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress.
8. An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If extension cord must be used make sure:
a.
That blades of extension cord are the same
number, size, and shape as those of plug on
battery charger:
b.
That extension cord is properly wired and in
good electrical condition; and
c.
That wire size is large enough for AC ampere
rating of battery charger as specified in
Table 1.
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5)
50 (15)
18
18
18
18
18
18
9.
Do not operate battery charger with damaged cord
or plug-replace them immediately.
10. Do not operate battery charger if it has received a
sharp blow, been dropped, or otherwise damaged
in any way; take it to a qualified serviceman.
100 (30)
150 (45)
18
16
16
14
16
14