Installation - Goobay 44529 Mode D'emploi

3. Mark the mounting hole spacing X and grommet Y by using the
mounting bracket and a suitable pen.
Fig. 10: Wall mounting
Article number
44529, 44530, 44531, 44532
Tab. 4: Mounting hole spacing X and grommet Y
4. Drill the mounting holes with a suitable tool.
5. Attach the LED floodlight motion sensor.
6

Installation

• Let open cable ends ONLY assemble by
experienced electrician.
• Cut off power supply before any work on the product, switch off
safety fuse and secure against reconnection.
• Assure and check the absence of voltage before any work on
the product.
Models without a mated protective contact plug must be permanently
installed on the power supply.
The power cables used must have a minimum cross-section of 1.0 mm².
Strands must be provided with wire end ferrules.
The following connections are made at the luster terminal of the
product:
Risk of electric shock
X
120 mm
Y
Ø 8,5 mm
14