EUROM Mon Soleil 300 Ceiling Manuel D'utilisation page 26

stops blinking and goes completely green and the blinking P on the Smart Plug
screen disappears.
 The connection process is complete.
 Press the ON/OFF button (9) on the Smart Plug; the heating panel can now be
operated using the Smart Plug.
Note: The heating panel can now only be operated with the Smart Plug. The
communication distance between the Smart Plug and the panel is a maximum of 30 m
(without any obstacles).
Connect multiple panels to the same Smart Plug
Connect the first heating panel as described above. Once the first panel has been
successfully connected, follow the same procedure for the second, and other heating
panels.
Once connected, check whether all of the linked heating panels respond simultaneously
when you set the desired temperature using the Smart Plug.
The red indicator light 'heating' should go on and off on all of the linked panels at the
same time.
Operating the heating panel with the Smart Plug
Before: The main switch on the heating panel (4) must be set to ON and the green
indicator light 'connecting' (1) must be lit up. The Smart Plug must be inserted into a
suitable socket and switched on via the ON/OFF button (9).
Please note (1): Before operating the heating panel with the Smart Plug/Eurom Smart
App, check to ensure that the green light on the heating panel is on (continuously). If the
green light is blinking or not on, there is no connection between the heating panel and
the Smart Plug. You can then use the buttons on the Smart Plug but commands will not
be passed onto the heating panel.
Please note (2): If the Smart Plug temporarily loses its 230 Volt supply, the Smart Plug
and the heating panel will be switched off when the 230 Volt supply is reconnected. This
prevents the room being heated to an undesirable temperature.
1. The ambient temperature will be displayed on the Smart Plug. The word ROOM will
appear on the display to indicate that the environmental temperature is shown.
(The set temperature is the last temperature that was set or 18 degrees, the first
time the device is used). If the set temperature is higher than the ambient
temperature, the heating panel will begin to heat; the heating symbol will be shown
on the Smart Plug display, and the red light will light up on the heating panel.
The Wi-Fi symbol will blink on the Smart Plug display. If the Wi-Fi symbol blinks, it
means that a connection can be made with the App (smartphone). (see details in the
back of this instruction booklet.
2. The + and – buttons (8) can be used to adjust the desired temperature (0-37
degrees). The word 'SET' will appear on the Smart Plug display to indicate that you
have set a desired temperature. After a few seconds, the desired temperature will
26