EUROM Mon Soleil 300 Ceiling Manuel D'utilisation page 25

Set up and operation
Operation panel on the heating panel and Smart Plug operation panel:
1. Indicator light - connecting (green)
2. Indicator light - heating (red)
3. P-button heating panel
4. ON/OFF button heating panel
5. Display Smart plug
Setting up - connecting the heating panel with the Smart Plug
 Make sure that the heating panel and the Smart Plug are not damaged.
 Insert the plug from the heating panel into the socket.
 Insert the Smart Plug into a suitable socket.
 The Smart Plug contains the temperature sensor. When you set the temperature
with the thermostat, the temperature is measured by the Smart Plug. Take this
into account when positioning the Smart Plug.
 Set the main switch on the heating panel (4) to ON (I): the green indicator light
'connecting' (1) will blink. The heating panel is now on stand-by.
 (If the green light (1) on the heating panel does not blink, the heating panel is in
the so-called ByPass mode; press the P button (3) on the heating panel twice and
the green light will start to blink.)
 Connect the heating panel as follows with the Smart Plug:
 Press the ON/OFF button (9) on the Smart Plug until 'OFF' is shown in the Smart
Plug display. Press and hold the P button (10). The P signal will blink on the
Smart Plug screen. Wait until the green indicator light on the heating panel (1)
6. Timer button
7. Wi-Fi button
8. +/- buttons (thermostat)
9. ON/OFF button Smart Plug
10. P button Smart Plug
25