Kemper Clean Air Tower Mode D'emploi page 66

It is necessary to check dust container filling in regular intervals and the container
must be replaced when necessary.
The interval for dust container replacement depends upon dust type and quantity. For
that reason, the operator should check container filling regularly in order to avoid in
overfilling.
The dust container should be replaced always in time in order to avoid contamination
of environment!
The filter system should be switched off when checking the fill level. Activate the
On/Off switch and wait until the light ring on the on/off switch completely stops
blinking. Then pull out the mains plug.
Then proceed as follows:
• Lift the dust collector container(pos. 1) a bit (A), until it releases from the
magnet holder (pos. 2).
• Pull out the underside of the dust collector container (pos. 1) far enough (B),
so that at the magnet holder (pos. 2) it can be pulled down (C). The remove it
by pushing it back (D).
• Close the opening to the dust collection container (pos. 3) using the attached
sticker (pos. 4) which is located in the dust collection container.
• Insert a new dust collection container in reverse order. Please ensure that the
seal (pos. 3) on the dust collection container (pos. 1) is not damaged and that
the dust collection container (pos. 1) is noticeably held by the magnet holder
(pos. 2).
Serial No.: 150 2206
Technical modifications without previous notification and errors reserved.
KEMPER CleanAirTower Instruction manual - EN
Figure 9, Dust container replacement
- 66 - Rev.: 2
Status as of: 09/2015