ULTIMATE SPEED 102049 Instructions D'utilisation Et Consignes De Sécurité page 14

Safety Information / Using the aluminium jump leads
T he product is not a toy and should be kept out
of the reach of children. Children cannot recog-
nise the risks that arise through use of the product.
DANGER TO LIFE! Keep
children away from the work area when the
products is being used.
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they have
been given supervision or instruction concerning
use of the appliance in a safe way and under-
stand the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
CAUTION! RISK OF EXPLO-
SION! Do not use the aluminium
jump lead in an environment in
which explosions may occur or where there
are combustible vapours, gases or dusts.
Danger to life from
electric shock
B efore using the aluminium jump lead, always
check it for any possible damage. Do not use
the Aluminium jump lead if you see it is dam-
aged in any way.
CAUTION! Damaged cables represent a risk
to life from electric shock. Contact your service
centre or an electrician if the product is dam-
aged, needs being repaired or has some other
problem with it.
N ever open one of the electrical equipment
(cables) or place any objects into them. Such
procedures could put your life at risk from
electric shock.
Safety instructions for
the aluminium jump leads
The capacity of the starter battery that is pro-
viding the power, e.g. 45 A / h, (car B) must
not be significantly lower than the flat starter
14 GB
battery (car A), if this is not the case it will not
be possible to start the vehicle. There is danger
of overheating.
Only connect batteries of the same nominal
voltage (12 or 24 volt) with the aluminium
jump leads. Otherwise there is danger of short
circuit, as well as danger of damaging the on-
board electronics and electrical components.
The bodies of the vehicles (cars A and B) must
not touch. Otherwise there is danger of short
circuit.
FIRE HAZARD! Keep ignition
sources (e.g. open flame, burning
cigars, cigarettes or electric sparks)
away from the starter batteries.
CAUTION! DANGER OF INJURY! DAN-
GER OF EYE INJURIES! Do not bend over
the starter batteries. The electrolyte is also in a
liquid state at low temperatures and regardless
of the charge status.
The flat starter battery (car A) must not be sep-
arated from its corresponding power supply
network during the starting aid process.
The ignitions of the vehicles must be switched
off before thealuminium jump leads cable are
connected, and the parking brake must be en-
gaged. With manual gearboxes, put the gear
lever into the neutral position, with automatic
gearboxes put the gear selector into "P".
Position the aluminium jump leads in such a
manner that they cannot be caught up in the
moving parts of the engine.
Using the aluminium
jump leads
Connecting
Note: First check whether the two batteries, donor
battery (car B) and flat battery (car A) have the
same voltage (12 or 24 volt) and approximately
the same capacity. Compare the label information
on the batteries!