Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Loosen the collet nut and insert the wheel point into the
collet nut. Use the smaller wrench to hold the spindle
and the larger one to tighten the collet nut securely.
The wheel point should not be mounted more than 10
mm (3/8") from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
To remove the wheel point, follow the installation
procedure in reverse.
10 mm (3/8") MAX.
015678
CAUTION:
A 1/4" collet cone is provided as standard
•
equipment. Use an optional collet cone 1/8" to
install a 1/8" shank wheel point.
OPERATION
CAUTION:
ALWAYS hold the tool firmly with one hand on
•
housing and the other on the side handle.
Apply light pressure on the tool. Excessive
•
pressure on the tool will only cause a poor finish
and overloading of the motor.
015008
Turn the tool on without the wheel point making any
contact with the workpiece and wait until the wheel point
attains full speed. Then apply the wheel point to the
workpiece gently. To obtain a good finish, move the tool
in the leftward direction slowly.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wheel points
•
Collet cone set (1/4", 1/8")
•
Wrench 13
•
Wrench 19
•
Side handle set
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
7
or
attachments
Only use
accessory or
are
Publicité
Table des Matières
