Setting The Detector - Velleman PIR45 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
1.
Test the detector at the point of time you feel the lamp needs to
be switched on.
2.
Turn the LUX knob fully clockwise; turn the TIME knob fully anti-
clockwise.
3.
Switch on the power. The detector needs a warm-up time of
± 30 seconds before it will switch on the connected lamp. When
no signal is detected, the lamp will switch off after
± 10 +/- 3 seconds.
4.
Turn the LUX knob fully anti-clockwise. The lamp should switch
off.
5.5

Setting the Detector

1.
Turn the LUX knob until the lamp switches on.
2.
Now, set the switch-off delay with the TIME knob going from
± 10 seconds to ± 15 minutes.
3.
Close the detector with the cover and tighten the screw.
6.
Cleaning and Maintenance
The detector does not need any particular maintenance. However,
occasionally wipe it with a damp cloth to keep it looking new. Do not
use harsh chemicals, cleaning solvents or strong detergents.
7.
Technical Specifications
detection
angle ............................................................... 360°
distance ..................................... max. 8 m (< 24 °C)
motion speed ........................................ 0.6 - 1.5 m/s
ON-timer ......................... 10 s (± 3 s) > 15 min (± 2 min)
switch type ............................................................. relay
light sensitivity ............................. 3-2000 lux (adjustable)
rated load
incandescent lamps .................................max. 800 W
energy-saving lamps ...............................max. 400 W
operating temperature ........................... -20 °C to +40 °C
power supply ..................................... 220-240 V~, 50 Hz
V. 01 – 17/05/2017
PIR45
5
©Velleman nv

Publicité

Table des Matières
loading

Table des Matières