Motor Protection Filter - Philips FC9219 Mode D'emploi

English
14
4 Lift the filter cylinder case out of the bucket.
5 Turn the handle on top of the filter cylinder case anticlockwise (1)
and lift the filter cylinder out of the case (2).
6 Clean the filter cylinder and the case with the brush supplied. Brush
from the top of the filter downwards along the ribs of the filter.
Only use the brush supplied. Other brushes may damage the filter
cylinder.
7 If there is dirt on the inside of the case, empty the case over a
dustbin.
8 If you wish, you can clean the filter cylinder case with cold tap water
and some washing-up liquid.
9 If you want to wash the filter cylinder, wash it thoroughly with only
water. Do not use any soap, washing-up liquid or other detergent
to clean the filter. Let the filter cylinder dry completely before you
reinsert it into the case.
10 Put the filter cylinder back into the case and turn the handle
clockwise until the filter cylinder locks into position.
Make sure the filter cylinder is securely fixed in the case.
11 Put the case with the filter cylinder back into the dust bucket.

motor protection filter

Clean the permanent motor protection filter every time you clean the filter
cylinder case.
1 Take the motor protection filter out of the appliance. Clean the filter
by tapping the dust out of it over a dustbin.
If the motor protection filter is very dirty, you can also rinse it with cold tap
water.
Do not use washing-up liquid or any other cleaning agent to clean the
motor protection filter.
2 Press the clean filter firmly back into the filter compartment to
ensure that it is properly placed.