Connecting Speakers; Connecting Headphones; Connecting The Power; Installing Batteries - Insignia NS-R5100 Guide De L'utilisateur

Connecting speakers

Front right Front left
Surround
right
Caution
Use speakers with an impedance of 6 Ω or more.
Caution
Do not let the bare speaker wires touch each other
or any metal part of this receiver. Doing so may
damage the receiver or speaker.
Note
Before connecting the speakers, refer to "Locating
your speakers" on page 5.
To connect your speakers:
• Connect your speaker cables to the receiver.
Be sure to connect the speakers firmly and
correctly according to the channel (left and
right) and the polarity (+ and -). If you do not
make the connections correctly, you will not
hear any sounds from the speakers.
If the sound is unnatural and lacks bass, the
speaker polarity is incorrect.
After installing the speakers, adjust the
speaker settings according to your
environment and speaker layout. For more
information, see "Modifying the speaker
settings" on page 19.
8
Center
Surround
left
www.insignia-products.com
Insignia NS-R5100 AV Digital Home Theater Receiver

Connecting headphones

To connect your headphones:
• Insert the headphone plug into the
headphone jack on the receiver.
Notes
• To hear sound from the headphones, make
sure the SPEAKER button is set to off.
• When listening to a DTS or Dolby Digital
program source, if the headphones are
plugged in and the SPEAKER button is set to
off, the receiver enters the 2CH downmix mode
automatically. For more information, see "2CH
downmix mode" on page 13.
• When EXTERNAL IN is selected as an input
source, only the front left and front right
channel signals can be reproduced through the
headphones.

Connecting the power

To connect your receiver to power:
• Plug the power cord into an AC outlet.

Installing batteries

Caution
Do not use Ni-Cd rechargeable batteries in this
remote control.
To install the batteries:
1 Remove the cover.