Restore Factory Settings - Schlage BE365 Mode D'emploi

Lock Issue
Cannot add a new User
Code.
Cannot delete a User Code.
Cannot change
Programming Code.
Cannot delete all User
Codes.
Lock will not stay in
programming mode.
* Number of beeps if beeper is turned on.

Restore Factory Settings

If you lose or forget your Programming Code, you can
restore the factory settings, which will restore the default
Programming code.
1. Disconnect the battery.
2. Press and release the Schlage button.
3. The following steps must occur within 10 seconds:
a. Reconnect the battery. The Schlage button will
light green for one second.
b. Then, press and hold the Schlage button until it
lights green and the lock beeps.
4. Try entering one of the default User Codes. If it does
not unlock the lock, start over at step 2.
Once you've done this, you can change the programming code to a personalized number. See Changing the
Programming Code* on page 11.
Beeps* Lights Solution
19 User Codes already exist. Delete a User Code
High/
Red before adding a new one. See Deleting User Codes
Low
on page 11.
Second User Code entered did not match first User
Code entered. See Adding User Codes* on page
11.
2 Red
The User Code matches the first four digits of the
existing Programming Code.
Second User Code entered did not match first User
2 Red
Code entered.
Second Programming Code entered did not match
first Programming Code entered. See Changing the
Programming Code* on page 11.
2 Red
First four digits of new Programming Code match an
existing User Code.
2 Red Programming Code entered second time is incorrect.
Any key other than
after programming mode was entered.
2 Red
An incorrect entry was made during the programming
process.
was pressed immediately
WARNING
Locate the default Programming and User
Codes on the front of this guide or the back
of the Keypad Assembly before beginning!
Default Programming and User Codes will be
restored. All existing User Codes and current
Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE
LOST DEFAULT CODES! DO NOT RESTORE
FACTORY SETTINGS UNLESS YOU CAN
LOCATE THE DEFAULT CODES.
15