Description Of The Appliance - HAEGER VC-70C.042A Mode D'emploi

Description of the appliance

A - Universal floor and carpet brush
B - Telescopic metal tube
C - Airflow control
D - Bend tube
E - Flexible suction hose
F - Suction hose connection
G - Handle
H - Automatic cable rewind pedal
I - On/Off pedal Power button
J - Dust cup clip
K - Multi cyclonic plastic filter
L - Filter clip (not shown)
M - HEPA FILTER access panel
Switching on and operation
1. Insert the flexible suction hose (E) into the suction hose connection (F) so that
it clicks into position. Pressing the release button will help you remove the
hose.
2. Attach the telescopic metal tube (B) to the handgrip of the flexible suction
hose.
3. Fit the universal floor and carpet brush (A) to the vacuum tube. The crevice
adaptor can also be affixed to the handgrip of flexible hose.
4. Holding the power cord by the plug, pull out the required length and plug it
into the mains socket.
*Attention: Don't extend the cable beyond the RED mark.
5. Press the On/Off pedal power button (I). Regulate the power using the
power regulator. The intensity can be regulated from the handgrip. Opening
the flap reduces suction, whereas closing it increases suction.
6. You can use the parking aid on the back of the vacuum cleaner if you wish
to stop vacuuming for a short while. Slide the catch on the brush into the
groove at the rear of the appliance.
7. The wheels and 360° swivel joint and the carrying handle makes this vacuum
cleaner extremely mobile.
Instructions for use
English
3