Initial Use; Network Configuration - LENCO DIR-60 Mode D'emploi

1. Display
2. Left
3. Standby
4. Menu
5. Vol/Nav/Ok/Scroll Press=Select
6. Fav
7. Dimmer
8. Right
9. Power on/off
10. DC IN
11. Aux in (3.5mm)
12. Headphone out (3.5mm)

2. INITIAL USE

Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
Switch the device on with the power switch on the rear.
When it is the first time running the device, the system will ask you to set Language and Network
Configurations.You may setup the network connection immediately, or set it later.Use Navigate to
select the desired option.Press Navigate/OK to confirm.
Press Standby button when unit is power on, unit will go to standby mode. Press again will make it
On again.

3. Network configuration

1. Normal network configration
Select "Yes" for the normal Wireless Network Configuration: The select the required AP by turning
"Navigate" and confirm it by pressing "Navigate/OK".
Enter WEP or WPA code to connect the WiFi network by select the correct character turning the
"Navigate/OK" button.
Press button to select the next character.
In this condition, press button you can turn left and delete the left chracters at the same time:
When the password is complete please press "Navigate/OK" button to confirm.
6