Bosch PTK 3,6 LI Notice Originale page 29

To estimate the exposure to vibration accurately, the times when the tool is
switched off or when it is running but not actually being used should also be
taken into account. This can significantly reduce the exposure to vibration
over the total working period.
Implement additional safety measures to protect the operator from the ef-
fects of vibration, such as servicing the power tool and application tools,
keeping the hands warm, and organising workflows correctly.
Assembly
Battery Charging (see figure A)
Use only the power adaptors listed in the technical data. Only these
u
power adaptors are matched to the lithium-ion battery of your power
tool.
Pay attention to the mains voltage. The voltage of the power source
u
must match the voltage specified on the rating plate of the power ad-
aptor. Power adaptors marked with 230 V can also be operated with
220 V.
Note: The battery is supplied partially charged. To ensure the maximum per-
formance of the battery, use the power adaptor to fully charge the battery
before first use.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by "Electronic
Cell Protection (ECP)". A protective circuit switches the power tool off when
the battery is drained.
Do not continue to press the trigger after the power tool has auto-
u
matically switched off. This can damage the battery.
To charge the battery, connect the Micro USB port (4) to the power ad-
aptor (9) via the USB cable (8). Plug the power adaptor into a plug socket.
The charging process will begin.
The battery charge indicator (2) indicates the charging progress. During the
charging process, the power tool is deactivated and cannot be used. During
the charging process, the handle of the power tool will normally heat up.
If you are not planning to use the power tool again soon, disconnect the
power adaptor (9) from the mains.
Bosch Power Tools
English | 29
1 609 92A 5KH | (19.06.2020)