Personal Protective Equipment - Husqvarna FS5000 D Manuel D'utilisation

• Listen for warning signals and voices when you use
hearing protection. Remove the hearing protection
when the product is stopped, unless hearing
protection is necessary for the noise level in the work
area.

Personal protective equipment

WARNING: Read the warning instructions
that follow before you use the product.
• Always use approved personal protective equipment
when you operate the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
• Regularly do a check of the condition of the personal
protective equipment.
• Use an approved protective helmet.
• Use approved hearing protection.
• Use approved respiratory protection.
• Use approved eye protection with side protection.
There is a high risk of eye injury from thrown objects.
• Use protective gloves.
• Use boots with steel toe-cap and non-slip sole.
• Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Fire extinguisher
• Keep a fire extinguisher near during operation.
• Use a powder fire extinguisher of "ABE" class or a
carbon dioxide fire extinguisher of "BE" type.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Machine stop button
The machine stop button quickly stops the engine and
all electrical functions but not the lights. The machine
1143 - 002 - 08.07.2019
stop button sets the product in safe mode. The product
cannot start again until the safe mode is reset.
Note: Do not use the machine stop button to stop the
product unless there is an emergency. For correct
procedure how to stop the product during operation,
To stop the product on page 26 .
refer to
To do a check of the machine stop button
1. Start the engine. Refer to
page 22 .
2. Push the machine stop button. The engine stops and
the product is set to safe mode.
3. Pull out the machine stop button to reset the
machine stop.
4. To reset the safe mode, turn the engine start switch
to engine stop position (B) and then to ignition on
position (A).
A
To start the product on
B
11