Compass / Air Pressure / Altitude; Timer - Timex Metropolitan Smart: Square Dial Mode D'emploi

Compass / Air Pressure / Altitude

®
Your TIMEX Metropolitan S has a compass and an air pressure sensor. When you select this mode you will
enter the compass page. If calibration is necessary the watch will prompt you to walk in a figure 8 to perform
the calibration. Once it finishes calibrating it will vibrate and then will show you the compass display with
your current heading and a pointer to north.
Swiping up on the compass page brings you to the air pressure page. Swiping up a second time brings you to
the altitude page. Both of these modes require initial calibration using the GPS. To perform the GPS
calibration for the pressure sensor, swipe to the altitude screen and go outdoors where there is a clear view of
the sky. The GPS animation at the bottom of the screen will change from incrementing orange bars to
stationary green bars when the GPS calibration is complete. Once complete your altitude and coordinates will
be shown and you can swipe down to move to the air pressure page.

Timer

The Timer mode provides a stopwatch function with 1/100 second resolution and 99 laps.
Swipe left to switch from an analog timer to a digital one.
Tap the start button (play symbol) to start the timer.
Tap the stop button (pause symbol) to pause or stop the timer.
Tap the Lap button to record a lap (and you can swipe to the digital timer screen and scroll up or down on the
display to see the list of laps)
Once stopped, tap the reset button to clear the timer.
16