Installation - Lehmannaudio Black Cube Mode D'emploi

34 Black Cube/Black Cube SE

Installation

EN
This section tells you about the connections, control elements
and application possibilities of your Lehmannaudio Black Cube/
Black Cube SE phono amplifier.
1 | Unpacking
After unpacking the Black Cube/Black Cube SE check it for possible transport
damages. If you notice visible damages, you must by no means connect the
device to mains. In this case consult your dealer immediately.
Delivery includes the following components:
Black Cube device
≠
Power supply (Black Cube) or
≠
PWX power supply (Black Cube SE)
Mains cable
≠
Note
We recommend keeping the entire packaging for later shipment.
That way you will avoid transport damages. Use by no means
'foam chips' or similar packaging material. Otherwise the device
will jolt through to the bottom of the cardboard box during
transport and can be damaged! If the original packaging is no
longer available, it's best to use bubble wrap in which to wrap up
the device in a generous manner. Finally the whole should be put
into a solid cardboard box.
User manual
≠
Allen key (2 mm)
≠
4 jumpers
≠
Certificate of warranty
≠
2 | Setup
Always position the Black Cube/Black Cube SE on a stable surface. Thanks to the
compact dimensions and low weight, you can set up the Black Cube/Black Cube
SE directly next to the record player.
3 | Connecting
Check whether the included mains adapter is suitable for connection to the
mains network used in your country. On the adapter, you will find information
about the specified mains voltage for the device. Now connect the Black Cube/
Black Cube SE to the mains network using the external power supply and the
connection on the rear of the device.
Note the safety instructions starting on page 30!
Black Cube/Black Cube SE 35
EN