Operating Determinations - EuroLite Flexilight Mode D'emploi

Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class III.
The device always has to be operated with an appropriate transformer. (Valid for articles 80702305,
8070230I and 807023049).
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

OPERATING DETERMINATIONS

This device is a lamp for illuminating mixers, turntables, etc. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz with transformer (articles 80702350 - 80702355 with an alternating
voltage of 12 V, 50 Hz) and was designed for indoor use only.
Lamps are not designed for permanent operation. Consistent operation breaks will ensure that the device will
serve you for a long time without defects.
Never put any liquids close to the device. Should any liquid enter the device nevertheless, disconnect from
mains immediately. Please let the device be checked by a qualified service technician before you operate it
again. Any damages caused by liquids having entered the device are not subject to warranty!
Do not shake the device. Avoid brute force when operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than 0.2 meters.
The housing must never touch surrounding surfaces or objects.
9/19 00026842.DOC, Version 2.2