Table des Matières

Publicité

EN
Setting the Emulation
The default setting of the printer comes with the MARTEL emulation setting.
It is also possible to set the CITIZEN emulation. This setting allows connecting older, no more produced
equipment's, which are not fitted out with Martel driver.
It concerns the following equipment's:
Wicometre Professional, Watch Expert, Watch Expert II, Q Test 6000.
The equipment's must be directly connected to the printer with the black Adapter Cable (accessory no.
95.13.202).
Procedure
Setting the CITIZEN emulation:
Switch the printer OFF.
Press and hold the
pressed until the * PRINTER SETUP * is printed.
Press the button
Feed
Press button
printed out (Do not modify Parameters!). Finally the setting is confirmed by with the print out of
* PRINTER SETUP * CITIZEN.
Setting the MARTEL emulation:
Same procedure as described above.
Print
Feed
and
buttons and switch ON the printer. Keep
Print
(Printer Emul.: MARTEL)  Press button
shortly 13 times in succession. After each pressing the appropriate parameter is
Print
- 4 -
Print
Feed
and
again (Printer Emul.: CITIZEN).
buttons

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jb01-740rs232

Table des Matières