Publicité
SETUP
Go into SETUP mode by pressing Key
1.
GB
FEED and Key PRINT and turn power on at
the same time.
2. The printer should print all list of the
parameters:
- Printer emulation: CITIZEN, MARTEL
(1)
- Protocol
: No Addressable* or Addressable
(1)
- Baud Rate
4800, 2400, 1200.
- Data length
(1)
- Parity
: None*, even or odd.
- Handshaking
- Autofeed: CR disabled* or CR enabled
- Panel keys: Enabled* or disabled.
- Print mode: Normal* or Reverse.
With "MARTEL" :
Chars / line: A=32 / B=42 col. * or
A=42 / B=56 col.
With "CITIZEN" :
Font dimens : 8x24* 56 col. 40 col.
- Speed: Normal* or Low.
(1)(2)
- Offline
: Disabled* or enabled
- Print density: Normal*, Dark, Light.
Notes: The parameters indicated with a *
symbol are the default values.
NOTE: Parameter valid only on serial printer.
(1)
NOTE: Using this parameter, it is possible to
(2)
select whether the Busy signal is activated
when the printer is both in Off Line status and
the buffer is full, or only if the reception buffer
is full.
‐ 13 ‐
: 57600, 38400,19200 *,9600,
(1)
: 7, 8 bits/chr *.
(1)
: XON/XOFF* or Hardware.
Publicité
