Health O Meter 402KLWA Mode D'emploi page 2

PHYSICIAN BEAM SCALE
MODEL: 402KLWA
Assembly & Operating Instructions
Your Scale is a precision instrument and should be handled accordingly. Remove all parts carefully to prevent
scratching the finish. In assembling the parts, do not use force since the scale has been assembled at our plant and all
parts will fit properly if instructions are followed.
Carton Contents – 1 Pillar/Beam, 1 Base, Counterweight(s) (one 40 kg & one 150 lb) 4 Pillar Nuts and Wrench
Assembly Instructions
1. Insert studs at lower end of pillar into the four holes provided in the base (See Fig 1).
2. Tip scale at angle (See Fig 2) resting top of pillar on any convenient support and using the wrench provided,
secure pillar to base with the four nuts (included).
3. Pull the Steel Rod toward the Base by grasping the Finger Pull Loop on the end.
4. Hook the Steel Rod into the Lever Extension by pushing the Lever Extension toward the beam with your hand.
While holding this position the hook on the Steel Rod is easily attached to the hole at the end of the Lever
Extension. Release the Finger Pull Loop and the scale is ready to use.
Note: The proper position of the multi-lever assembly in order to attach the steel rod to the base is shown in
Figure 3. This assembly must be free floating in the pillar head. This can be observed through the opening
between the Pillar Head and the Pillar.
5. Stand the scale upright.
6. To increase your scale's capacity by using the included counterweight(s), please refer to section "Using
Counterweights".
1