Brandt FC1141X Manuel D'utilisation page 14

3.3 Rough-walled models. Catalytic enamel
(self-degreasing). On these models, the
rear plate and side panels are covered with a
self-cleaning enamel that removes the grease
while the oven is functioning. The side panels
are reversible, doubling the lifetime of the
coating.
To remove the self-cleaning panels, fi rstly
remove the side rails (3.2.1) (3.2.2).
If the panels are not performing the self-
cleaning process suffi ciently, they will need
regenerating. To do this, remove all the
accessories and utensils from the inside of
the oven. Thoroughly clean the oven surfaces
that are not self-cleaning. Select the
function.
Set the temperature to 250ºC and set the
time between 30 and 60 minutes, depending
on how dirty the oven is.
When the cleaning programme ends and
the oven has cooled down, wipe the self-
cleaning elements with a damp sponge. They
will then be totally functional again.
Note: Do not use specifi c oven cleaning
products to clean the catalytic walls.
Do not scrape the surface with metal
scouring pads or sharp or pointed
instruments.
3.4 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before
removing it.
• Never use steam cleaning machines.
4
Troubleshooting
You can solve the following problems yourself:
4.1 4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
12
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
4.4 A beep is sounding. The selected
temperature setting has been reached. The
cooking cycle is complete.
4.5 The oven makes a noise after cooking.
This is normal, as the fan keeps running until
the temperature inside and outside the oven
is reduced.
4.6 "0 00" appears on the display. The
temperature sensor has failed. Call the
Technical Service.
4.7 "AS" appears on the display. The oven has
been functioning for several hours and has
switched off automatically for safety reasons.
Do not try to repair the oven yourself. Call
the technical assistance service.
5
The Environment
This oven has been designed with
environmental protection in mind.
Respect the environment. Only preheat the
oven when necessary (see table). Use dark
coloured cake tins whenever possible. For
long cooking times, switch off the oven 5 or 10
minutes before the end of cooking time.
Management of waste electrical and
electronic equipment.
The symbol indicates that the appliance must
not be disposed of in traditional bins for domestic
waste.
Take your oven to the a special collection centre.
Recycling domestic appliances will prevent
negative consequences for health and the
environment and will allow savings on energy and
resources.
For further information, contact the local
authorities or the shop where you bought the
oven.
e n g l i s h