Assembly And Learning - Beeper IV05 Manuel D'installation & D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
BATTERY USE (CONTINUED)
2. Charger usage precautions
Please read the following instructions carefully before each use of the charger:
The charger only works with the dedicated AC adapter. Using any other adapter may damage the product.
The adapter should be plugged into a normal, easily accessible household outlet.
Do not cover, expose to heat or moisture and use in a ventilated area.
Do not place other equipment on the charger.
Do not leave the charger plugged in when not in use.
Do not use the charger if it is damaged.
The external flexible cable of this transformer cannot be replaced. If the cord is damaged, the transformer should
be scrapped.
Never connect and disconnect the battery connection terminals while the power cable is still connected to the
mains. Always remove the plug from the socket first.
Do not store your mains charger in low temperature areas. When the device returns to its normal temperature,
moisture can form inside the device and damage the electronic circuits.
Unplug the charger during lightning storms or when unused for long periods of time to avoid damage.
ASSEMBLY & LEARNING
1. Assembly of the balance bike
Upon receipt of your Beeper product, your product is already assembled, ready to operate.
All you have to do is unfold it by following the instructions below:
To unfold your product, straighten the mast upwards and lock the
folding system
Warning
• Folding and unfolding your product can be difficult during the first few uses.
• Before folding your product, make sure that it is switched off.
2. Using the balance bike
1.
Install yourself on your product.
2.
Insert the key in the nemann and turn it a first time to switch on the ignition.
3.
Turn the key a second time to start the engine of your product and turn on your front and rear lights.
4.
Place one of your feet on the footrest and turn the throttle grip.
5.
Once you gain some speed, put the second foot on its footrest.
6.
Press the accelerator to move forward.
7.
Apply the brakes to slow down.
13

Publicité

Table des Matières
loading

Table des Matières