Danby Designer DPA100D1MDD Guide D'utilisation Et Soins De Propriètaire page 10

Cooling mode
• When the A/C enters cooling mode automatically or cooling mode is selected after it's turned on, the cooling indicator
lamp lights up.
• Press Up/Down button to adjust temperature setting between 17°C~30°C (62.6°F~ 86°F).
• Press Speed button to choose High/Low fan speed.
Fan mode
• When pressing mode button or choosing fan mode by pressing the remote control, the fan indicator lamp lights up, the
unit will run under fan mode.
• Press Speed button to choose High/ Medium/ Low fan speed.
• Temperature can't be set in fan mode.
Auto mode
• Press mode button from control panel or choose auto mode from remote control to enter auto mode. Auto indicator lamp
will light up when under auto mode.
After choosing auto mode, operation setting is determined by ambient temperature: when ambient temperature is
higher than 25°C (77°F), the operation setting is the same as that of cooling mode; when it is lower than 25°C (77°F), the
operation setting is the same as that of fan mode.
Max cool mode (optional)
• Under cooling mode press TIMER and UP buttons at the same time to enter Max. cool mode.
• In Max. cool mode, the A/C will cool in regardless of temperature restriction.
• In Max. cool mode, fan speed is high, and it can't be adjusted.
• To cancel Max cool mode press the TIMER and UP buttons again.
Sleep mode (optional)
• Press TIMER and DOWN button at the same time while in cooling mode to enter sleep mode.
• Under this mode, the set temperature increases by 1° after the unit running for 2 hours, and 2 hours later it'll increase by
another 1°, after that it won't change any more.
• Under this mode, the fan blows at low speed and fan speed cannot be adjusted.
Timer mode
• In standby mode (no mode selected) press the timer button to set TURN ON time. Press Up and Down buttons to set
TURN ON time (0~24H), and the timer indicator lamp lights up.
• Press timer button to set TURN OFF time when the unit is on. Press Up and Down buttons to set TURN OFF time
(0~24H), and the timer indicator lamp lights up.
DRAINAGE
METHOD
• If the internal vessel is full of water, the display
screen will display "FL", and the compressor stops
working automatically. Turn the unit off, unscrew
the drain cover, pull out the water plug to drain
out the water, and compressor will return to normal
after being restarted.
OPERATING INSTRUCTIONS
This product is equipped with an automatic water evaporative system. The condensed
water is recycled to cool the condenser, which improves cooling effi ciency and saves
energy.
7