User Manual
Receiver Unit
1. Power / Connection LED: Please see below for the
different LED Indication definitions.
2. Mini-USB PSU Jack: Connect the included power
supply.
3. Optical In: Connect the SFP Module and Duplex Fibre
Cable.
4. DisplayPort Out: Connect DP display using DP cable.
5. USB Out: Connect to the USB HIDs.
6. USB Status LED: Once USB HID has been connected,
this LED will emit Orange. This will flash 1-3 times to
indicate the connected device number.
Troubleshooting
There is no display on the screen.
It has been found that there are significant differences in the cable lengths/types and even input ports
which can be used on different brands of display using DisplayPort resolutions. If problems are
experienced, please apply the following steps:
▪
Try a different input port on the display.
▪
Please ensure the display's input source is set to DP.
▪
Reduce the cable length on the Input and Output to 1m.
▪
Try a different type of 1m DisplayPort Cable.
▪
Check that the Micro-USB and plug used by the external power supply is firmly connected.
▪
Check that the fibre optic cable and modules are connected correctly.
▪
Power off all the devices, then power on in this order: first, the extender, then the display and finally
the source.
▪
Check the PC BIOS configuration for the video output settings
▪
Try to connect the PC and display with a direct connection to ensure the video signal is present.
Lindy regularly checks and tests our product range to ensure maximum compatibility and performance.
For the most up to date version of this manual, please refer to your local Lindy website, search for the
relevant part number and find the manual under Downloads.
English