Chassis; Fan; Filter; Motors - Vortice AIR-TEK PRO Série Notice D'emploi Et D'entretien

3.2.1. CHASSIS:

Soundproof 30mm extruded aluminum profile, nylon corners and pre lacquered steel sandwich panels, RAL
•
9006, class M0, with 25mm internal rockwool insulation class A1 (non-combustible) and 90Kg/m3 density.
Panels come with quick release fastening system for easy assembly and disassembly whenever required,
whether for cleaning, maintenance o panel repositioning.
Filters are located in the perforated side panels, with handles and fastening system. This ease of access
•
optimizes maintenance and filter replacement procedures. Filter replacement and manipulation of the AIR-
TEK PRO is recommended with the appropriate PPE's. See the 7. EQUIPMENT MAINTEANACE section to
know how to change the filters and their correct and safe handling.
AIR-TEK PRO purifiers are equipped with 4 wheels with brakes on the base for ease of mobility throughout
•
the interior spaces. The wheel set is included with the product, but they are not assembled; must be screwed
on the assembly (on extruded aluminum supports) before use.

3.2.2. FAN:

• Equipped with high efficiency single inlet - backward impeller with self-cleaning system, made of
polyamide, statically and dynamically balanced at the factory
3.2.3. FILTERS:
The AIR-TEK PRO is equipped with a dual filtering stage on each side of it: 4 filters are included: 2 un + 2 un:
2 un x ISO COARSE 65% (old G4) Pre-filter stage to protect from dust and dirt and
improve the shelf life of the main or absolute filter
2 un x HEPA H14 Main filtering stage of high or absolute efficiency

3.2.4. MOTORS:

-The ref. AIR-TEK PRO 150 and AIR-TEK PRO 300 are equipped with a low consumption EC (electronically
commutated) Technology exterior rotor motor. IP-44 protection and class B insulation. Standard voltage 230V
50Hz/60Hz

3.2.5. CONTROL PANEL:

• All AIR-TEK PRO air purifiers are equipped with a master control panel located on one side of
the structure.
27