Usb Port - JASNO MS3 Manuel D'utilisation

After pressing one of the Number buttons "1" through "4", the louvers will
automatically start calibration by moving up and down. Do not touch the
shutters or remote control button while the shutters are moving up and down.
Once the louvers have stopped moving, check the angle at which the louvers
are positioned. If the louvers are positioned optimally, they should be
positioned perfectly horizontally (maximum openness).
If the louvers are tilted slightly upward, press the bottom most "Angle" key
once to adjust the louvers downward to the perfectly horizontal position. If the
louvers are tilted slightly downward, press the top most "Angle" key to adjust
the louvers upward to the perfectly horizontal position. After you have pressed
either the bottom or top "Angle" key once, check to see if the louver is in the
perfectly horizontal position. If not, repeat as necessary.
If you had pressed the top "Angle" key to move the louver one increment up,
you should notice that the Low Battery Indicator will light. However, if you had
pressed the bottom "Angle" key, the Low Battery Indicator will not light.
During the recalibration process, the Low Battery Indicator is used to remind
the user that as part of the calibration finalization process, the bottom "Angle"
key must also be pressed, once the optimal horizontal angle position has been
obtained. Thus, if you had to press the top "Angle" key to compensate the louvers
to tilt upwards, you would need to press the bottom "Angle" key. However, if you
were compensating downwards and pressing the bottom "Angle" key, you do not
have to press the "down" key again since you have already pushed it.
If you have done everything correctly so far, the On/Off indicator should be
on, and the Battery Indicator Light should be off. To close synchronization
mode, now press number "1" and "All" key simultaneously for 3 seconds. The
on/off indicator will turn off, and your shutters will automatically move to a
70 degree position. After your shutters have stopped moving, your shutters
are now synchronized, the synchronization process has concluded, and you
may begin the programming phase.

USB port

The USB port can be used to synchronize the remote with the calendar to
install the timer function.
30