Getting Started; Battery Installation Remote Control; Battery Installation Receiver/ Driver - JASNO MS3 Manuel D'utilisation

Getting started

Battery installation remote control
The RF remote control requires 2 pieces of AAA Alkaline batteries 1.5V.
To install the batteries, turn over the remote and open the cover. Insert the
batteries matching the (+) and (-) marks and cover the bottom cover. If the
battery has been properly installed, the light stripe will light up.
Remote Control
Back Cover
Battery installation receiver/ driver
Place the panel into the Remote mode by following the instructions under
Manual tilting mode.
/ driver affects how your shutters are programmed. Please see "Programming
Instructions" for details. To install batteries, open the battery cover and
remove the battery cartridge. Insert 6 pieces AA Alkaline batteries 1.5V
(for solar use rechargeable!) matching the (+) and (-) marks inside the battery
cartridge. Put back the cartridge and reinstall the battery cover.
Receiver / driver
22
The order in which batteries are installed in the receiver
Battery cover Battery cartridge
Blue light stripe
Pole marks
(+) and (-)