How To Group Shutters (Step 2); Reset Groups At Any Times; Using Your Remote - JASNO MS3 Manuel D'utilisation

How to Group Shutters (Step 2)
After you have pressed "1", this concludes the first step. In the second step,
install all the batteries to modules in the second group. Do not take out the
batteries from the modules that have already been assigned to group 1. With
batteries installed in all group 1 and group 2 modules only, press any one of
the eight "Angle" keys. It does not matter which one you push. Now, press
the "Number" key you'd like to program. For instance, if you'd like to assign
button "2" to the second group of modules you have just installed batteries for,
press "2". This concludes step two. You can repeat the process up to 5 groups.
Reset groups at any times
If you want to reset any of the drivers at any point, just take out the battery
and then re-install it. Don't forget the batteries of the extra battery unit if
available.

Using your remote

With all groups programmed, you can easily tilt any group of shutters. To begin,
first press the "Angle" key that corresponds to the angle you wish to tilt. Then
press the number key that corresponds to the group number you'd wish to tilt:
this will tilt all shutters in the group to the desired position. To tilt all shutters
at once, press the desired "Angle" key and then press "All".
24