Advanced Features (Calibration); Buttons And Indicators Of Calibration Mode - JASNO MS3 Manuel D'utilisation

Advanced features (Calibration)

Buttons and indicators of calibration mode
Low Battery Indicator
Your RF system may require calibration to ensure optimal louver alignment
after prolonged use. The calibration feature should only be attempted by a
technician.
To start calibration, take out the battery from the receiver / drivers that
you'd like to calibrate. This will wipe out the receiver / drivers' programming
memory, and will require reprogramming after the calibration process. You
may calibrate as many receiver / drivers as you'd like at the same time as long
they're all in range. With the batteries taken out from the receiver / drivers you
wish to calibrate, reinstall the batteries. Don't forget the batteries of the extra
battery unit if available.
Now press the number key "1" and the "All" key simultaneously for about
3 seconds. After you have held down the buttons for about the buttons for
3 seconds, the on/off signal will light towards the top of the remote control.
Once the light is lit, you are in synchronization mode.
When you are in synchronization mode, press the Number key "1", "2", "3"
or "4" that corresponds to the louver size of your shutters.
• Press "2" for 63mm louvers.
• Press "3" for 89mm louvers.
• Press "4" for 114mm louvers.
English User manual RF remote MS3
On/Off Indicator
Top Angle Key
Bottom Angle Key
29