Safety Instructions - HBM C2 Notice De Montage

Safety Instructions

1 Safety Instructions
4
Intended use
Force transducers in the C2 type series are designed
solely for measuring static and dynamic compressive
forces within the load limits stated in the specifications.
Any other use is not appropriate.
To ensure safe operation, it is essential to comply with
the regulations in the mounting instructions, the safety
requirements listed below, and the data specified in the
technical data sheets. It is also essential to observe the
applicable legal and safety regulations for the relevant
application.
Force transducers are not intended for use as safety
components. Please also refer to the "Additional safety
precautions" section on the following page. Proper and
safe operation of force transducers requires proper trans­
portation, correct storage, setup and mounting, and care­
ful operation.
Load‐carrying capacity limits
The information in the technical data sheets must be
complied with when using force transducers. The respec­
tive specified maximum loads in particular must never be
exceeded. The following limits set out in the technical
data sheets must not be exceeded:
S Force limits
S Lateral force limits
S Bending moment and torque
S Breaking forces
S Permissible dynamic loads
A0674-5.0 HBM: public
C2