Bresser 40-640x Mode D'emploi page 16

After use
To make your experiment set - and the enjoyment of it - last longer, you
should make note of the following for after each use.
1. Clean the slide covers , slides and the microscope instruments care-
fully with water and some soap.
Caution!
Slide covers, slides and the instruments have sharp edges and
are in some cases pointed. Make sure to always let adults help
you when cleaning, so that you don't hurt yourself!
Warning! The slide covers are particularly thin and could break. It is best to
place them on a piece of paper on a hard surface for cleaning.
2. Close all the vials tightly after use. Some containers have liquids that
evaporate very easily, and could dry up.
7. Smartphone holder
Attach the smartphone holder to the eye-
piece. The suction cups must be clean and
free from dust and dirt. A slight moistening is
helpful. Now press your smartphone on the
retaining plate and make sure that it is prop-

erly secured. As a backup, you should secure
it with the enclosed rubber strap. Smart-
phones with a rough surface will not hold as
good as smartphones with a smooth surface. Now start the Camera app.
The camera needs to rest just above the eyepiece. Center the smartphone
exactly over the eyepiece, so the image can be seen precisely centered on
16
your screen. In some cases you need to adjust with the zoom function to
display the image fullscreen. A light shading at the edges is possible.
Take the smartphone carefully off the holder after use.
NOTE:
Make sure that the smartphone can not slip out of the holder. Bresser GmbH
assumes no liability for any damages caused by a dropped smartphone.
8. Troubleshooting
Error Solution
No recognizable • Turn on light
image • Readjust focus
Notes on Cleaning
• Before cleaning the device, disconnect it from the power supply by
removing the batteries.
• Only use a dry cloth to clean the exterior of the device. To avoid
damaging the electronics do not use an cleaning uid.
• Protect the device from dust and moisture.
• The batteries should be removed from the unit if it has not been used
for a long time.
EC Declaration of Conformity
Bresser GmbH has issued a 'Declaration of Conformity' in
accordance with applicable guidelines and corresponding
standards. The full text of the EU declaration of conformity is
available at the following internet address:
www.bresser.de/download/9619760/CE/9619760_CE.pdf