Imetec R7506 Instructions D'utilisation page 19

but at the end of the drying cycle it must be air-dried to allow it to dry completely.
• Remove the throw from the tumble dryer at the end of the drying cycle and reshape it
to its original size.
• Allow the throw to fully air-dry before using it again.
DRYING IN THE OPEN AIR
• When the throw is spread out to dry on a clothes airer, it must be stretched so the original
size is more or less maintained. This is best done while the throw is still damp, working
alternately on the opposite corners and pulling one side at a time. You might have to repeat
this procedure several times until the throw is completely dry.
WARNING! Dry the appliance flat without using pegs to avoid
damaging it. Leave it to dry, laid out flat on a clothes airer, not
in direct sunlight.
• Only use the throw when it's thoroughly dry.
• Do not iron the throw.
WARNING! Examine the appliance against the light to make sure
the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or if
problems arise with the internal cables contact an authorised service
centre for a safety check.
When not in use, store as follows:
• If the throw has been washed, wait until it's completely dry;
• Fold it like a normal throw;
• You are advised to store the throw in the original packaging it was supplied in;
• When storing the appliance, allow it to cool down before folding;
• Put the throw away in a dry place.
Examine the appliance and its supply cord frequently for signs of wear or damage.
lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
STORING THE THROW
EN
18