Important - Imetec R7506 Instructions D'utilisation

inserted, the control unit automatically performs a self-diagnosis, lighting up all LEDs
(10, 11) in a clockwise sequence for around two seconds.
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
The control unit can be set to the following temperature levels:
6: Fast pre-heat temperature
5-4: Medium pre-heat temperature
3-1: Continuous or all-night use
• To switch the throw on press the ON/OFF button (7). Every time the appliance is turned on,
the control unit automatically checks the appliance is working correctly, lighting up all LEDs
(10, 11) in a clockwise sequence. Following this check, the control unit automatically sets
temperature 6 and the timer (auto-off time) to 1 hour.
• For fast pre-heat, use maximum temperature 6. If you like a medium pre-heat temperature,
then you can select 4-5 by pressing the temperature selector button (8) until the LED for
the required temperature lights up (11). The higher the number selected, the higher the
temperature.
IMPORTANT: The time needed for the throw to warm up will depend on the room
temperature. To judge the temperature accurately, lie on your sofa with the throw
draped over you. Do not rely on a hand placed on the throw.
CONTINUOUS USE
For continuous use, set the control unit to temperature levels
from 1 to 3 only.
To set the control unit to the continuous use temperature, press the temperature selector button
(8) until LEDs 1, 2 or 3 light up (11).
DO NOT set the control unit to a higher temperature than
recommended for continuous use.
If the control unit is set to a higher temperature the user may
suffer skin burns or heat stroke.
WARNING!
or under the sheets when in use.
DO NOT place the control unit under the pillow
EN
16