Operation - Michelin 92409 Mode D'emploi

5. OPERATION

Please note the recommended tyre pressure for your vehicle in your
vehicle owner's handbook.
Do not measure the tyre pressure on warm tyres (e.g. after long
drives).
TO TEST TYRE PRESSURE:
1. Remove the dust cap from the tyre valve.
2. Press the button
3. Press the pressure gauge nozzle firmly onto the tyre valve so that
no air can escape. The reading is shown.
4. Remove the pressure gauge from the tyre valve.
„ The reading is shown for 10 seconds and then switches to
"0.00". The device automatically switches off after another 10
seconds.
„ As long as the display is switched on, the test can be repeated
at any time irrespective of the reading shown.
5. Screw the dust cap back onto the tyre valve.
The tyre pressure can be displayed in two different units (bar and
PSI).
Additionally, a target air pressure can be entered for the front and
back tyres. Set the target air pressure according to your vehicle speci-
fications. The respective target air pressure serves as a comparison
value during the measurement.
SETTING THE MEASURING UNIT AND TARGET AIR PRESSURE:
1. Press the
2. Keep the
mode.
3. Select the desired measuring unit PSI or BAR (presetting PSI) using
the buttons and confirm the selection with the
4. Select the front or rear tyres (blinking symbol) using the
tons and confirm the selection with the
5. Set the target pressure value for the selected tyres using the
buttons and confirm the selection with the
pressure value for the other tyres is shown.
6. Set the target pressure value for the selected tyres using the
buttons and confirm the selection with the
„ The settings are shown for 2 seconds so they can be checked.
The display then switches to "0.00". The device is set.
CHECKING THE TYRE PRESSURE WITH PRESET TARGET MEASUREMENT
READING
1. Remove the dust cap from the tyre valve.
2. Press the
3. Select the target value for the tyre to be tested (front or rear tyres)
using the
to activate the display.
button to activate the display.
button pressed for 3 seconds to switch to the set-up
button to activate the display.
button.
button.
button.
button. The target
button.
EN
but-
13