Prepare The Receiver Collar; Inserting And Removing The Battery - Petsafe Spray Commander PDT17-14140 Manuel D'utilisation

STEP 2

Prepare the Receiver Collar

Threading the Nylon Collar onto the Receiver
1. Remove the Keeper from the nylon collar. Pass the nylon collar through the loops of the receiver.
Put the Keeper back on the nylon collar. The curved edge of the Keeper should face inward.
2. Feed the free end of the nylon collar into the slot of the buckle from the back to the front. Then,
thread the free end of the nylon collar through the outside slot from the front to the back. The free
end should now hang on the outside, then thread the Keeper.

Inserting and Removing the Battery

1. Insert a coin into the slot of the Battery Cover and turn it towards the open position (2A). Remove
the Battery Cover (2B).
2. Insert one 6-Volt Battery with the positive end towards the bottom of the Receiver Collar (2C).
Replace the Battery Cover by turning it to the OFF (O) position with a coin (2D).
8
2A
2C
www.petsafe.net
2B
2D