Lupus Electronics LUPUSNIGHT LE-308 Manuel De L'utilisateur page 18

Connection
STEP 7: Connect the camera video output and the monitor video input with a 75
coaxial cable.
STEP 8: Connect the camera to proper power supply.
e) Get a proper power cord and cut off the female connector. Remove the
insulating coating to reveal two wires as shown in Pic 9-1.
f) Twist these two wires with the corresponding wires on the camera as shown in
Pic 9-2.
g) To protect the naked wires, use the insulation tape to cover on the twisted
wires as shown in Pic 9-3.
h) Connect the male connector of the power cord into the power socket.
NOTE: Please connect to the correct power supply to operate this unit. Over maximum power input will damage
this unit.
Description
This new innovative "IRpro" surveillance camera was specifically developed for maximum security
environments with bad lighting conditions both by day and at night. Its high resolution Sony® DSP
CCD chip delivers 480 TV-lines at 752x582 pixels. 102 High-End-LEDs allow for a night vision
coverage of 50 meters. Equipped with its groundbreaking "IR Shifter" and "Smart Light Control"
technologies as well as a large aperture (F1.4), this IR-surveillance camera combines incredibly sharp
images under most difficult lighting conditions with amazing durability and absolute reliability. The
"Advanced Night Vision Control" system dynamically regulates the required illumination intensity
according to lighting conditions at hand. The specifically designed weather- and vandal-proof housing
(safety class IP 67) is powered by a 220V cable, a 12 V adapter is already integrated. The technology
is perfectly shielded from heat and cold. A built-in heater protects the camera against temperature
variations and fogging at high humidity conditions and thus guarantees constant high quality video
transmissions. A massive wall mount with rotatable joint is included.