Troubleshooting Guide - Metabo HPT G 3612DA Instructions De Sécurité Et Mode D'emploi

Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Symptom
Tool doesn't run
Tool suddenly stopped
Abnormal noise.
Grinding wheel shakes
Brake doesn't operate
properly.
Battery cannot be
installed

TROUBLESHOOTING GUIDE

WARNING
Possible cause
No remaining battery power
Battery isn't fully installed.
Foreign matter is keeping the lock pin
pressed down.
The battery is installed while the switch is
turned ON.
Tool was overburdened
Overload protection is in operation.
The battery is overheated.
Wheel nut is loose.
The wheel nut, wheel rusher, grinding
wheel, etc. are improperly installed facing
the wrong direction.
Foreign matter is caught between the
wheel nut, wheel washer, grinding wheel,
etc.
Main unit may be at fault.
Attempting to install a battery other than
that specifi ed for the tool.
Remedy
Charge the battery.
Push the battery in until you hear a click.
Remove the foreign matter from the lock
pin.
Turn the switch OFF and then ON again.
Get rid of the problem causing the
overburden.
Let the battery cool down.
Fully tighten the wheel nut.
Check the installed direction and correctly
install the parts.
Remove the foreign matter.
Immediately discontinue use and contact
your dealer for repairs.
Please install a multi volt type battery.
English
21