Signature SFM3502XAQUANF Instructions D'utilisation page 31

9.Water Dispenser (optional)
III. Installation
1. Installation of water valve components
The guiding boss on the water valve components shall
be in alignment with the guiding slot on the base, and
press it down in the direction of in the direction of 45° of
oblique downward by hands with strength, until you
may hear the sound of "click."
2. Installation of water tank sealing ring
To install the sealing ring on the bottom of water tank
by hand, make sure that it is properly installed, and the
wrinkling and oblique installation and so on shall be
avoided.
3. Installation of water tank components
The hanging slot on the water tank components shall be
in alignment with the suspension loop on the inner layer,
and the sealing ring at the bottom of water tank shall be
in alignment with the entrance of water value components,
and then insert them into the corresponding positions in
the direction of 45° of oblique downward by hands.
- 29 -