Silverline 660471 Mode D'emploi page 8

GB
Disposal
Always adhere to national regulations when disposing of power tools that are no
longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
Troubleshooting
Problem
Tool will not operate
Tool runs or cuts slowly
Makes an unusual sound
Excessive vibration
Heavy sparking occurs inside
Motor Housing (12)
8
Possible cause
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Speed Control Dial (7) set low
Motor is overloaded
Mechanical obstruction
Armature has shorted sections
Incorrectly fitted or loose accessory
Bent or damaged accessory
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Solution
Check that power is available at source
Have carbon brushes replaced by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Resharpen or replace cutter
Increase variable speed setting
Reduce pushing force on tool
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre
Refit or tighten accessory
Replace accessory
Have carbon brushes checked and replaced by an authorised Silverline
service centre
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre