Gong Wing PULSE 2 Guide De L'utilisateur page 16

3 - Tightly close the low section of the Inflation Valve.
5 - Open the clip for the ONE-PUMP System for strut
inflation off one valve.
7 - Disconnect the Pump Tube.
8 - Close the Valve and cover with neoprene
protector.
9 - Tighten the clip of the ONE-PUMP System on the
inflatable central batten. In the case of a leading edge
or pierce strut during navigation, this will allow you to
maintain a safety float.
EN
4 - Unscrew the top section of the Valve and insert
the Pump Tube.
6 - Inflate the Wing between 8-10 PSI. DO NOT Over
Inflate the Wing.
10 - Take the Pump Leash off while holding the Wing
so it does not get picked up by the wind.
11 - Turn the Wing over, Intrado facing the ground,
Leading Edge facing the wind and use the sand
for anchoring the Wing.
- 16