Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION INSTRUCTION
•
Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
•
Pay attention to the mounting place and all mounting material(dowels, screws). Ensure they
are suitable and stable enough for mounting and lastingly holding of the appliance.
• Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
• The distance between the bottom edge of the appliance and the floor must be at least 1.8 M.
See figure 2.
•
There must be a distance of at least 0.25 M between the appliance and the ceilings, roofs or
other covers. See figure 2.
•
There must be a distance of at least 0.5 M at each side between the appliance and walls
or the like. See figure 2.
• Recommended degree to mounting surface is 45°. See figure 3.
•
Pay attention that, the installation of the appliance must not add excessive wind load.
• Fix the mounting bracket to the ceiling l first. Ensure that the place to be installed is secure
and firm. Or connect the appliance to the stand.
•
Adjust the desired angle of radiation and fest screw all screws. Check regularly the screw's
connection. Mechanical bearing pressure and oscillation due to wind or rain could lead
to loose.
•
Plug in the power source and operate the remote control. Then observe, whether during the
first 10-15 minutes the appliance works trouble-free.
•
If you do not use,please remove battery socket
Publicité
Table des Matières
