Guarantee & Service - Philips HD3720 Mode D'emploi

ENGLISH
22
7 Remove the aluminium plate.
After you have removed the aluminium plate, you see a
,
white plate of approx. 4 x 4cm. This is the actual cooling
element.
8 Place the shaft of a screwdriver against one side of the
cooling element and push the cooling element off the back
of the aluminium plate.
9 Cut the wires attached to the cooling element.
Do not connect the appliance to the mains again after you
have removed the cooling element.
Never reassemble the cooling element once you have removed it.
10 Hand in the cooling element at an official collection point
for chemical waste.
Guarantee & service
If you need information or if you have a problem, contact us
online at www.philips.com or call the PerfectDraft call centre.
Their phone number is 078-250159 (Belgium), 040 80 80 10 980
(Germany) or 0900-2224222 (Netherlands).
When you take the appliance to your dealer or a Philips service
centre for determination of the cause of the problem, also bring
the tube and the keg.
Guarantee restrictions
Your guarantee becomes invalid if:
-
you do not use the appliance according to the instructions
in this user manual.
-
you use damaged kegs in this appliance.
- you do not install the kegs according to the instructions in
this user manual.
- you use kegs from other suppliers than the ones mentioned
in this user manual.
The kegs and tubes are not covered by this guarantee.
,
Troubleshooting
If you are unable to solve the problem with the information
below, contact us online at www.philips.com or call the
PerfectDraft call centre at 078-250159 (Belgium), 040 80 80 10
980 (Germany) or 0900-2224222 (Netherlands).